Install Guide
Table Of Contents
- Dell EMC PowerSwitch S6100-ON Installation Guide March 2021
- About this guide
- S6100–ON system
- Site preparations
- NEBS compliance
- S6100–ON installation
- Power supplies
- Fans
- Management ports
- Dell support
- Specifications
- Chassis physical design
- IEEE standards
- Agency compliance
- USA Federal Communications Commission (FCC) statement
- European Union EMC Directive Conformance statement
- Japan: VCCI Compliance for Class A Equipment
- Korean Certification of Compliance
- Safety Standards and Compliance Agency Certifications
- Electromagnetic Compatibility (EMC)
- Product recycling and disposal
About this guide
This guide provides site preparation recommendations, step-by-step procedures for rack mounting and desk mounting, inserting
optional modules, and connecting to a power source.
Topics:
• Notices
• Related documents
Notices
CAUTION: To avoid electrostatic discharge (ESD) damage, wear grounding wrist straps when handling this
equipment.
NOTE: Only trained and qualified personnel can install this equipment. Read this guide before you install and power up this
equipment. This equipment contains two power cords. Disconnect both power cords before servicing.
NOTE: This equipment contains optical transceivers, which comply with the limits of Class 1 laser radiation.
Figure 1. Class 1 Laser Product Tag
NOTE: When no cable is connected, visible and invisible laser radiation may be emitted from the aperture of the optical
transceiver ports. Avoid exposure to laser radiation and do not stare into open apertures.
Related documents
For more information about the S6100–ON system, see the following documents:
● Dell Getting Started Guide for the S6100–ON System
● Dell Release Notes for the S6100–ON System
● Open Networking (ON) Hardware Diagnostic Guide
● Dell Command Line Reference Guide for the S6100–ON System
● Dell Configuration Guide for the S6100–ON System
NOTE: For the most recent documentation, visit Dell Support: www.dell.com/support.
1
About this guide 5