Install Guide
Table Of Contents
- Dell EMC PowerSwitch S6100-ON Installation Guide March 2021
- About this guide
- S6100–ON system
- Site preparations
- NEBS compliance
- S6100–ON installation
- Power supplies
- Fans
- Management ports
- Dell support
- Specifications
- Chassis physical design
- IEEE standards
- Agency compliance
- USA Federal Communications Commission (FCC) statement
- European Union EMC Directive Conformance statement
- Japan: VCCI Compliance for Class A Equipment
- Korean Certification of Compliance
- Safety Standards and Compliance Agency Certifications
- Electromagnetic Compatibility (EMC)
- Product recycling and disposal
System status
You can view S6100–ON status information using the LEDs.
LED display
The S6100–ON includes LED displays on the I/O side of the system.
NOTE: If you are installing third-party software, for LED information, see your third-party operating software
documentation.
LED behavior
The following S6100–ON system LED behavior is seen during open networking installation environment (ONIE) operations:
Figure 5. S6100–ON LEDs
1.
Fan LED 2. Power LED
3. Master LED 4. System LED
5. Locator LED 6. Locator LED
7. System LED 8. Port LEDs
9. Stack ID LED 10. RJ-45 Ethernet Management Port LED
Table 1. S6100–ON LED behavior
LED Description
System Status and Health LED
● Off—No power
● Solid green—Normal Operation
● Blinking green—POST is in process
● Solid amber—Critical system error
● Blinking amber—Minor system error
Power LED
● Off—No power
● Solid green—Normal Operation
● Solid amber—POST is in process
● Blinking amber—Noncritical system error—power supply
failure
S6100–ON system 9