Setup Guide

command, such as redistribute, trac passes through all instances of that route map until a match is found. The following is an
example with two instances of a route map.
The following example shows matching instances of a route-map.
DellEMC#show route-map
route-map zakho, permit, sequence 10
Match clauses:
Set clauses:
route-map zakho, permit, sequence 20
Match clauses:
interface TenGigabitEthernet 1/1/1/1
Set clauses:
tag 35
level stub-area
DellEMC#
To delete all instances of that route map, use the no route-map map-name command. To delete just one instance, add the sequence
number to the command syntax.
DellEMC(conf)#no route-map zakho 10
DellEMC(conf)#end
DellEMC#show route-map
route-map zakho, permit, sequence 20
Match clauses:
interface TenGigabitEthernet 1/1/1/1
Set clauses:
tag 35
level stub-area
DellEMC#
The following example shows a route map with multiple instances. The show config command displays only the conguration of the
current route map instance. To view all instances of a specic route map, use the
show route-map command.
DellEMC#show route-map dilling
route-map dilling, permit, sequence 10
Match clauses:
Set clauses:
route-map dilling, permit, sequence 15
Match clauses:
interface Loopback 23
Set clauses:
tag 3444
DellEMC#
To delete a route map, use the no route-map map-name command in CONFIGURATION mode.
Congure Route Map Filters
Within ROUTE-MAP mode, there are match and set commands.
• match commands search for a certain criterion in the routes.
• set commands change the characteristics of routes, either adding something or specifying a level.
When there are multiple match commands with the same parameter under one instance of route-map, Dell EMC Networking OS does a
match between all of those match commands. If there are multiple match commands with dierent parameters, Dell EMC Networking OS
does a match ONLY if there is a match among ALL the
match commands. In the following example, there is a match if a route has any of
the tag values specied in the match commands.
Example of the match Command to Match Any of Several Values
The following example shows using the match command to match any of several values.
DellEMC(conf)#route-map force permit 10
DellEMC(config-route-map)#match tag 1000
Access Control Lists (ACLs)
127