Setup Guide

• You must apply the CAM-ACL space for the FCoE region before enabling the FIP-Snooping feature. If you do not apply CAM-ACL
space, the following error message is displayed:
DellEMC(conf)#feature fip-snooping
% Error: Cannot enable fip snooping. CAM Region not allocated for Fcoe.
DellEMC(conf)#
NOTE: Manually add the CAM-ACL space to the FCoE region as it is not applied by default.
To support FIP-Snooping and set CAM-ACL, usecam-acl l2acl 2 ipv4acl 0 ipv6acl 0 ipv4qos 2 l2qos 0 l2pt 0
ipmacacl 0 vman-qos 0 fcoeacl 2 etsacl 1 iscsi 2 command.
CAM ACL Table
-- Chassis Cam ACL --
Current Settings(in block sizes)
1 block = 256 entries
L2Acl : 2
Ipv4Acl : 0
Ipv6Acl : 0
Ipv4Qos : 2
L2Qos : 0
L2PT : 0
IpMacAcl : 0
VmanQos : 0
EtsAcl : 1
FcoeAcl : 2
iscsiOptAcl : 2
ipv4pbr : 0
vrfv4Acl : 0
Openflow : 0
fedgovacl : 0
nlbclusteracl: 0
-- stack-unit 1 --
Current Settings(in block sizes)
1 block = 256 entries
L2Acl : 2
Ipv4Acl : 0
Ipv6Acl : 0
Ipv4Qos : 2
L2Qos : 0
L2PT : 0
IpMacAcl : 0
VmanQos : 0
EtsAcl : 1
FcoeAcl : 2
iscsiOptAcl : 2
ipv4pbr : 0
vrfv4Acl : 0
Openflow : 0
fedgovacl : 0
nlbclusteracl: 0
DellEMC(conf)#
Enabling the FCoE Transit Feature
The following sections describe how to enable FCoE transit.
NOTE
: FCoE transit is disabled by default. To enable this feature, you must follow the Congure FIP Snooping.
As soon as you enable the FCoE transit feature on a switch-bridge, existing VLAN-specic and FIP snooping congurations are applied.
The FCoE database is populated when the switch connects to a converged network adapter (CNA) or FCF port and compatible DCB
FIP Snooping
359