Setup Guide

TenGigabitEthernet 1/1/9/4 unassigned NO Manual administratively down down
fortyGigE 1/1/11 unassigned NO Manual administratively down down
fortyGigE 1/1/12 unassigned NO Manual administratively down down
fortyGigE 1/1/13 unassigned NO Manual administratively down down
fortyGigE 1/1/14 unassigned NO Manual administratively down down
TenGigabitEthernet 1/1/15/1 unassigned NO Manual administratively down down
TenGigabitEthernet 1/1/15/2 unassigned NO Manual administratively down down
TenGigabitEthernet 1/1/15/3 unassigned NO Manual administratively down down
TenGigabitEthernet 1/1/15/4 unassigned NO Manual administratively down down
fortyGigE 1/2/1 unassigned NO Manual administratively down down
fortyGigE 1/2/2 unassigned NO Manual administratively down down
To view only congured interfaces, use the show interfaces configured command in the EXEC Privilege mode.
To determine which physical interfaces are available, use the show running-config command in EXEC mode. This command displays
all physical interfaces available on the system.
DellEMC#show running-config
[output truncated]
interface hundredGigE 1/1/1
no ip address
shutdown
!
interface hundredGigE 1/1/2
no ip address
shutdown
!
interface hundredGigE 1/1/3
no ip address
shutdown
!
interface hundredGigE 1/1/4
no ip address
shutdown
Resetting an Interface to its Factory Default State
You can reset the congurations applied on an interface to its factory default state. To reset the conguration, perform the following steps:
1 View the congurations applied on an interface.
INTERFACE mode
show config
DellEMC(conf-if-te-1/1/5/1)#show config
!
interface TenGigabitEthernet 1/1/5/1
no ip address
portmode hybrid
switchport
rate-interval 8
mac learning-limit 10 no-station-move
no shutdown
2 Reset an interface to its factory default state.
CONFIGURATION mode
default interface interface-type]
DellEMC(conf)#default interface tengigabitethernet 1/1/5/1
3 Verify the conguration.
INTERFACE mode
Interfaces
415