Setup Guide

0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 00:27:30
Setting the Speed of Ethernet Interfaces
To discover whether the remote and local interface requires manual speed synchronization, and to manually synchronize them if necessary,
use the following command sequence.
1 Determine the local interface status. Refer to the following example.
EXEC Privilege mode
show interfaces [interface | stack—unit stack-unit-number] status
2 Determine the remote interface status.
EXEC mode or EXEC Privilege mode
[Use the command on the remote system that is equivalent to the rst command.]
3 Access CONFIGURATION mode.
EXEC Privilege mode
config
4 Access the port.
CONFIGURATION mode
interface interface-type
5 Set the local port speed.
INTERFACE mode
speed {10 | 100 | 1000 | 10000 | auto}
NOTE
: If you use an active optical cable (AOC), you can convert the QSFP+ port to a 10 Gigabit SFP+ port or 1 Gigabit
SFP port. You can use the speed command to enable the required speed.
6 Optionally, set full- or half-duplex.
INTERFACE mode
duplex {half | full}
7 Disable auto-negotiation on the port.
INTERFACE mode
no negotiation auto
If the speed was set to 1000, do not disable auto-negotiation.
8 Verify conguration changes.
INTERFACE mode
show config
Example of the show interfaces status Command to View Link Status
NOTE
: The show interfaces status command displays link status, but not administrative status. For both link and
administrative status, use the show ip interface command.
DellEMC#show interfaces status
Port Description Status Speed Duplex Vlan
448
Interfaces