Setup Guide

The default is 10 minutes.
9 (Optional) Congures DCBX to send iSCSI TLV advertisements.
LLDP CONFIGURATION mode or INTERFACE LLDP CONFIGURATION mode
[no] advertise dcbx-app-tlv iscsi.
You can send iSCSI TLVs either globally or on a specied interface. The interface conguration takes priority over global conguration.
The default is Enabled.
10 (Optional) Congures the advertised priority bitmap in iSCSI application TLVs.
LLDP CONFIGURATION mode
[no] iscsi priority-bits.
The default is 4 (0x10 in the bitmap).
11 (Optional) Congures the auto-detection of Compellent arrays on a port.
INTERFACE mode
[no] iscsi profile-compellent.
The default is: Compellent disk arrays are not detected.
Displaying iSCSI Optimization Information
To display information on iSCSI optimization, use the following show commands.
• Display the currently congured iSCSI settings.
show iscsi
• Display information on active iSCSI sessions on the switch.
show iscsi sessions
• Display detailed information on active iSCSI sessions on the switch . To display detailed information on specied iSCSI session, enter the
session’s iSCSI ID.
show iscsi sessions detailed [session isid]
• Display all globally congured non-default iSCSI settings in the current Dell EMC Networking OS session.
show run iscsi
Examples of the show iscsi Commands
The following example shows the show iscsi command.
DellEMC#show iscsi
iSCSI is enabled
iSCSI session monitoring is disabled
iSCSI COS : dot1p is 4 no-remark
Session aging time: 10
Maximum number of connections is 256
------------------------------------------------
iSCSI Targets and TCP Ports:
------------------------------------------------
TCP Port Target IP Address
3260
860
The following example shows the show iscsi session command.
VLT PEER1
DellEMC#show iscsi session
Session 0:
-----------------------------------------------------------------------------------
502
iSCSI Optimization