Setup Guide

24 bytes successfully copied

DellEMC#

DellEMC#copy tftp://10.16.127.35/username/dv-maa-test ?

flash: Copy to local file system ([flash://]filepath)

nfsmount: Copy to nfs mount file system (nfsmount:///filepath)

running-config remote host:

Destination file name [test.c]:

225 bytes successfully copied

DellEMC#

Save the Running-Conguration

The running-conguration contains the current system conguration. Dell EMC Networking recommends coping your running-conguration

to the startup-conguration.

The commands in this section follow the same format as those commands in the Copy Files to and from the System section but use the

lenames startup-conguration and running-conguration. These commands assume that current directory is the internal ash, which is

the system default.

• Save the running-conguration to the startup-conguration on the internal ash of the primary RPM.

EXEC Privilege mode

copy running-config startup-config

• Save the running-conguration to an FTP server.

EXEC Privilege mode

copy running-config ftp:// username:password@{hostip | hostname}/filepath/ filename

• Save the running-conguration to a TFTP server.

EXEC Privilege mode

copy running-config tftp://{hostip | hostname}/ filepath/filename

• Save the running-conguration to an SCP server.

EXEC Privilege mode

copy running-config scp://{hostip | hostname}/ filepath/filename

NOTE

: When copying to a server, a host name can only be used if a DNS server is

congured.

NOTE: When you load the startup conguration or a conguration le from a network server such as TFTP to the running

conguration, the conguration is added to the running conguration. This does not replace the existing running conguration.

Commands in the conguration le has precedence over commands in the running conguration.

Congure the Overload Bit for a Startup Scenario

For information about setting the router overload bit for a specic period of time after a switch reload is implemented, see the Intermediate

System to Intermediate System (IS-IS) section in the Dell Command Line Reference Guide for your system.

Viewing Files

You can only view le information and content on local le systems.

To view a list of les or the contents of a le, use the following commands.

• View a list of les on the internal ash.

EXEC Privilege mode

Getting Started