Setup Guide

Enabling LLDP on Management Ports
LLDP on management ports is enabled by default.
To enable LLDP on management ports, use the following command.
1 Enter Protocol LLDP mode.
CONFIGURATION mode
protocol lldp
2 Enter LLDP management-interface mode.
LLDP-MANAGEMENT-INTERFACE mode
management-interface
3 Enable LLDP.
PROTOCOL LLDP mode
no disable
Disabling and Undoing LLDP on Management Ports
To disable or undo LLDP on management ports, use the following command.
1 Enter Protocol LLDP mode.
CONFIGURATION mode.
protocol lldp
2 Enter LLDP management-interface mode.
LLDP-MANAGEMENT-INTERFACE mode.
management-interface
3 Enter the disable command.
LLDP-MANAGEMENT-INTERFACE mode.
To undo an LLDP management port conguration, precede the relevant command with the keyword no.
Advertising TLVs
You can congure the system to advertise TLVs out of all interfaces or out of specic interfaces.
• If you congure the system globally, all interfaces send LLDPDUs with the specied TLVs.
• If you congure an interface, only the interface sends LLDPDUs with the specied TLVs.
• If you congure LLDP both globally and at interface level, the interface level conguration overrides the global conguration.
To advertise TLVs, use the following commands.
1 Enter LLDP mode.
CONFIGURATION or INTERFACE mode
protocol lldp
2 Advertise one or more TLVs.
PROTOCOL LLDP mode
570
Link Layer Discovery Protocol (LLDP)