Setup Guide

show file-systems
The output of the show file-systems command in the following example shows the total capacity, amount of free memory, le
structure, media type, read/write privileges for each storage device in use.
DellEMC#show file-systems
Size(b) Free(b) Feature Type Flags Prefixes
4286574592 4170424320 FAT32 USERFLASH rw flash:
- - unformatted USERFLASH rw fcmfs:
2032525312 590807040 Unknown NFSMOUNT rw nfsmount:
- - - network rw ftp:
- - - network rw tftp:
- - - network rw scp:
- - - network rw http:
You can change the default le system so that le management commands apply to a particular device or memory.
To change the default directory, use the following command.
• Change the default directory.
EXEC Privilege mode
cd directory
View Command History
The command-history trace feature captures all commands entered by all users of the system with a time stamp and writes these
messages to a dedicated trace log buer.
The system generates a trace message for each executed command. No password information is saved to the le.
NOTE
:
The timestamps display format of the show command history output changes based on the service timestamps log
datetime conguration. The time format can be in uptime, local time zone time or UTC time.
If timestamp is disabled (no service timestamps log) then command history time format is shown with timestamp defaults
(service timestamps log datetime localtime).
To view the command-history trace, use the show command-history command.
Example of the show command-history Command
Example 1: Default conguration service timestamps log datetime or service timestamps log datetime
localtime
DellEMC(conf)#service timestamps log datetime
DellEMC# show command-history
- Repeated 1 time.
[May 17 15:38:55]: CMD-(CLI):[service timestamps log datetime]by default from console
[May 17 15:41:40]: CMD-(CLI):[write memory]by default from console
- Repeated 1 time.
[May 17 15:41:45]: CMD-(CLI):[interface tengigabitethernet 1/1/5]by default from console
[May 17 15:41:47]: CMD-(CLI):[shutdown]by default from console
[May 17 15:41:50]: CMD-(CLI):[no shutdown]by default from console
[May 17 15:42:42]: CMD-(CLI):[show clock]by default from console
[May 17 15:42:52]: CMD-(CLI):[write memory]by default from console
- Repeated 1 time.
[May 17 15:43:08]: CMD-(CLI):[end]by default from console
[May 17 15:43:16]: CMD-(CLI):[show logging]by default from console
Getting Started
59