Setup Guide
– number: the IPv4 address.
The format is A.B.C.D.
NOTE: Enter the router-id for an OSPFv3 router as an IPv4 IP address.
• Disable OSPF.
CONFIGURATION mode
no ipv6 router ospf process-id
• Reset the OSPFv3 process.
EXEC Privilege mode
clear ipv6 ospf process
Assigning OSPFv3 Process ID and Router ID to a VRF
To assign, disable, or reset OSPFv3 on a non-default VRF, use the following commands.
• Enable the OSPFv3 process on a non-default VRF and enter OSPFv3 mode.
CONFIGURATION mode
ipv6 router ospf {process ID}}
The process ID range is from 0 to 65535.
• Assign the router ID for this OSPFv3 process.
CONF-IPV6-ROUTER-OSPF mode
router-id {number}
– number: the IPv4 address.
The format is A.B.C.D.
NOTE
: Enter the router-id for an OSPFv3 router as an IPv4 IP address.
• Disable OSPF.
CONFIGURATION mode
no ipv6 router ospf process-id vrf {vrf-name}
• Reset the OSPFv3 process.
EXEC Privilege mode
clear ipv6 ospf [vrf vrf-name] process
Applying cost for OSPFv3
Change in bandwidth directly aects the cost of OSPF routes.
• Explicitly specify the cost of sending a packet on an interface.
INTERFACE mode
ipv6 ospf interface-cost
– interface-cost:The range is from 1 to 65535. Default cost is based on the bandwidth.
Open Shortest Path First (OSPFv2 and OSPFv3)
687