Users Guide

no-confirm
[discard-running]
Reload the chassis without prompting for further confirmation.
dell-diag (OPTIONAL) Reload the system into the Dell diagnostics mode.
onie (OPTIONAL) Reload the system into the ONIE mode. You can also use one of the
following options to reload the system and enter the respective modes directly:
● install — enter the Install mode and install the networking OS
● uninstall — enter the Uninstall mode and uninstall the networking OS
● rescue — enter the Rescue mode and access the file system
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0)
Added the optional dell-diag and onie parameters.
Introduced on the S6100-ON.
Introduced the no-confirm option.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
9.1(0.0) Added ‘conditional’ parameter.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information
If you use only the reload command, the system boots into the Dell Networking OS.
If there is a change in the running configuration, the system prompts you to save the new configuration
when you reload the system using the reload command. You can also save your running configuration
manually using the copy running-config command.
You can use the conditional parameter if any configuration changes made to the NVRAM, such as,
stack-group and fanout configurations, must be saved.
Example
The following example shows how to reload the system:
Dell# reload
Proceed with reload [confirm yes/no]: yes
The following example shows how to reload the system into Dell diagnostics mode:
Dell#reload dell-diag
Proceed with reload [confirm yes/no]: yes
Control and Monitoring 107