Users Guide

router rip
To configure and enable RIP, enter ROUTER RIP mode.
Syntax
router rip
To disable RIP, use the no router rip command.
Defaults Disabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage
Information
To enable RIP, assign a network address using the network command.
Example
Dell(conf)# router rip
Dell(conf-router_rip)#
Related
Commands
● network — enables RIP.
● exit — returns to CONFIGURATION mode.
show config
Display the changes you made to the RIP configuration. The default values are not shown.
Syntax
show config
Command Modes ROUTER RIP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Routing Information Protocol (RIP) 1117