Users Guide

● When you do not load the VRF microcode in the CAM, the VRID for a VRRP group is the same as the
VRID number configured with the vrrp-group or vrrp-ipv6-group commands.
● When you load the VRF microcode in the CAM, the VRID for a VRRP group equals 16 times the vrrp-
group or vrrp-ipv6-group vrid number, plus the ip vrf vrf-id number. For example, if
you load the VRF microcode and you configure the VRRP group as 10 in VRF 2, the VRID for the
VRRP group is (16 x 10) + 2, or 162. This VRID value is used in the lowest byte of the virtual MAC
address of the VRRP group and is also used for VRF routing.
NOTE: For all routers to interoperate, configure the same VRID on neighboring routers (Dell
Networking or non-Dell Networking) in the same VRRP group.
Related
Commands
● virtual-address — assigns up to 12 virtual IP addresses per VRRP group.
Virtual Router Redundancy Protocol (VRRP) 1439