Users Guide

Parameters
sequence-
number
Enter a number from 0 to 4294967290.
deny Enter the keyword deny to configure a filter to drop packets meeting this
condition.
permit Enter the keyword permit to configure a filter to forward packets meeting this
criteria.
source Enter an IP address in dotted decimal format of the network from which the packet
was received.
mask (OPTIONAL) Enter a network mask in /prefix format (/x) or A.B.C.D. The mask,
when specified in A.B.C.D format, may be either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject to the filter.
host ip-address Enter the keyword host then the IP address to specify a host IP address or
hostname.
count (OPTIONAL) Enter the keyword count to count packets the filter processes.
bytes (OPTIONAL) Enter the keyword bytes to count bytes the filter processes.
log (OPTIONAL) Enter the keyword log to enter ACL matches in the log.
dscp (OPTIONAL) Enter the keyword dcsp to match to the IP DCSCP values. The range
is from 0 to 63.
ecn (OPTIONAL) Enter the keyword ecn to match to the ECN values. The range is
from 0 to 3.
order (OPTIONAL) Enter the keyword order to specify the QoS order for the ACL
entry. The range is from 0 to 254 (where 0 is the highest priority and 254 is the
lowest; lower-order numbers have a higher priority). If you do not use the keyword
order, the ACLs have the lowest order by default (255).
monitor (OPTIONAL) Enter the keyword monitor then the session–ID to describe the
traffic that you want to monitor and the ACL in which you are creating the rule is
applied to the monitored interface. The session–ID range is from 0 to 65535.
NOTE: For more information, see “Flow-based Monitoring” in the Port
Monitoring section of the Dell Networking OS Configuration Guide.
fragments Enter the keyword fragments to use ACLs to control packet fragments.
no-drop Enter the keywords no-drop to match only the forwarded packets.
Defaults Not configured
Command Modes CONFIGURATION-STANDARD-ACCESS-LIST
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Added the no-drop parameter.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
174 Access Control Lists (ACL)