Users Guide

port port (OPTIONAL) Enter the application layer port number. Enter two port numbers if
using the range logical operand. The range is 0 to 65535.
The following list includes some common TCP port numbers:
● 23 = Telnet
● 20 and 21 = FTP
● 25 = SMTP
● 169 = SNMP
destination
address
Enter the IPv6 address of the network or host to which the packets are sent in the
x:x:x:x::x format followed by the prefix length in the /x format. The range is /0
to /128. The :: notation specifies successive hexadecimal fields of zero.
message-type (OPTIONAL) Enter an ICMP message type, either with the type (and code, if
necessary) numbers or with the name of the message type . The range is 0 to 255
for ICMP type and 0 to 255 for ICMP code.
count (OPTIONAL) Enter the keyword count to count packets processed by the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed by the filter.
Defaults Not configured.
Command Modes ACCESS-LIST
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.0.2.0 Introduced on the S6000.
8.4.2.1 Introduced on the E-Series TeraScale and S-Series.
8.2.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the C-Series.
7.4.1.0 Added the monitor option.
Related
Commands
deny – configures a filter to drop packets.
permit – configures a filter to forward packets.
Common MAC Access List Commands
The following commands are available within both MAC ACL modes (Standard and Extended) and do not have mode-specific
options. These commands allow you to clear, display, and assign MAC ACL configurations.
The platform supports both Ingress and Egress MAC ACLs.
The MAC ACL can be applied on Physical, Port-channel and VLAN interfaces. As per the specified rules in the ACL, the traffic
on the interface/ VLAN members or Port-channel members will be permitted or denied.
clear counters mac access-group
Clear counters for all or a specific MAC ACL.
Syntax
clear counters mac access-group [mac-list-name]
Parameters
mac-list-name (OPTIONAL) Enter the name of a configured MAC access list.
Access Control Lists (ACL) 205