Users Guide

cam-acl (Configuration)
Select the default CAM allocation settings or reconfigure a new CAM allocation for Layer 2, IPv4, and IPv6 ACLs, Layer 2 and
Layer 3 (IPv4) QoS, Layer 2 Protocol Tunneling (L2PT), IP and MAC source address validation for DHCP, Ethernet Connectivity
Fault Management (CFM) ACLs, OpenFlow, and Policy-based Routing (PBR).
Syntax
cam-acl {default | l2acl number ipv4acl number ipv6acl number ipv4qos
number l2qos number l2pt number ipmacacl number vman-qos | vman-dual-qos
number [etsacl number] [fcoe number][fedgovacl number] [nlbclusteracl
number] [ipv4pbr number] [openflow number] [vrfv4acl number]
[ipv4udfenable] [ipv4udfmirracl number]
Parameters
default Use the default CAM profile settings and set the CAM as follows:
● L2Acl : 2
● Ipv4Acl : 2
● Ipv6Acl : 0
● Ipv4Qos : 2
● L2Qos : 2
● L2PT : 0
● IpMacAcl : 1
● VmanQos : 0
● EtsAcl : 0
● FcoeAcl : 0
● ipv4pbr : 0
● vrfv4Acl : 0
● Openflow : 0
● fedgovacl : 0
● nlbclusteracl: 0
● ipv4udfmirracl: 0
l2acl number Enter the keyword l2acl and then the number of l2acl blocks. The range is from 0
to 8 in multiples of 2.
ipv4acl number Enter the keyword ipv4acl and then the number of FP blocks for IPv4. The range
is from 0 to 9 in multiples of 3, when ipv4udfenable is selected. If not enabled,
it is in multiples of 2.
ipv6acl number Enter the keyword ipv6acl and then the number of FP blocks for IPv6. The range
is from 0 to 9 in multiples of 3.
ipv4qos number Enter the keyword ipv4qos and then the number of FP blocks for IPv4. The
range is from 0 to 8 in multiples of 2.
l2qos number Enter the keyword l2qos and then the number of FP blocks for l2 qos. The range
is from 0 to 8 in multiples of 2.
l2pt number Enter the keyword l2pt and then the number of FP blocks for l2 protocol
tunnelling. The range is from 0 to 8 in multiples of 2.
Ipmacacl number Enter the keyword ipmacacl and then the number of FP blocks for IP and MAC
ACL. The range is from 0 to 9.
etsacl number Enter the keyword etsacl and then the number of FP blocks for ETS ACL. The
range is from 0 to 9.
nlbclusteracl
number
Enter the keyword nlbclusteracl and then the number of FP blocks for
nlbcluster ACL. The range is from 0 to 9. By default, the value is 0 and it supports 8
NLB arp entries reserved for internal functionality.
NOTE: When you reconfigure CAM allocation, use the nlbclusteracl
number command to change the number of NLB ARP entries. The range is
from 0 to 9. The default value is 0. At the default value of 0, eight NLB ARP
376 Content Addressable Memory (CAM)