Users Guide

entries are available for use. This platform supports up to 512 CAM entries.
Select 1 to configure 256 entries. Select 2 to configure 512 entries. Even
though you can perform CAM carving to allocate the maximum number of NLB
entries, Dell Networking recommends that you use a maximum of 64 NLB ARP
entries.
vman-qos Enter the keyword vman-qos and then the number of FP blocks for VMAN QoS.
The range is from 0 to 9.
Ipv4pbr number Enter the keyword ipv4pbr and then the number of FP blocks for ipv4pbr ACL.
The range is from 0 to 8.Each PBR entry is carved out in double wide mode. While
carving, specify only even groups for PBR.
Openflow number Enter the keyword openflow and then the number of FP blocks for open flow.
The range is from 0 to 9 in multiples of 3.
fcoeacl number Enter the keyword fcoeacl and then the number of FP blocks for FCOE ACL. The
range is from 0 to 8 in multiples of 2.
Iscsioptacl
number
Enter the keyword iscsioptacl and then the number of FP blocks for iSCSI
optimization ACL. The range is from 0 to 9.
l2acl number
ipv4acl number
ipv6acl number ,
ipv4qos number
l2qos number l2pt
number ipmacacl
number
{nlbclusteracl]
[vman-qos |
vman-dual-qos
number ] ipv4pbr
number openflow
{4|8} | fcoe
number
[iscsioptacl
number ]
[vrfv4acl
number ]
Allocate space to each CAM region.
Enter 4 or 8 for the number of OpenFlow FP blocks.
● 4: Creates 242 entries for use by the OpenFlow controller (256 total entries
minus the 14 entries reserved for internal functionality)
● 8: Creates 498 entries for use by the OpenFlow controller (512 total entries
minus the 14 entries reserved for internal functionality)
The fcoe range is 0–8 groups. Each group has 256 entries; the value given must be
an even number. This information is stored in the NVRAM and is effective after
rebooting the switch.
ipv4udfmirracl
Enter the keyword ipv4udfmirracl and then the number of FP blocks for IPv4
UDF mirror ACL. The range is from 0 to 8.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.11(0.0) Added the keyword ipv4udfmirracl.
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added the nlbcluster ACL keyword. Introduced on the S6000-ON.
9.4.(0.0) Added support for PBR and VRF.
9.2(1.0) Introduced on the Z9500.
9.2(0.2) Added support for fcoe.
Content Addressable Memory (CAM) 377