Users Guide

● For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then
the stack/slot/port information.
● For a port channel interface, enter the keywords port-channel then a
number.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the Z9500 and S6000-ON.
9.2(0.2) Introduced on the S4810 and S4820T. Added the receive parameters packet-
type and interfaces and their options.
feature fip-snooping
Enable FCoE transit and FIP snooping on a switch.
Syntax
feature fip-snooping
To disable the FCoE transit feature, use the no feature fip-snooping command.
Defaults Disabled
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
Usage
Information
Before enabling FIP snooping, assign the fcoeacl space using the cam-acl command. If not assigned, the
following error message is displayed:
Dell(conf)#feature fip-snooping
% Error: Cannot enable fip snooping. CAM Region not allocated for Fcoe.
Dell(conf)#cam-acl l2acl 2 ipv4acl 0 ipv6acl 0 ipv4qos 2 l2qos 0 l2pt 0
ipmacacl 0 vman-qos 0 fcoeacl 2 etsacl 1 iscsi 2
Dell(conf)#feature fip-snooping
FIP Snooping 491