Users Guide

disable
Disable the resilient ring protocol.
Syntax
disable
To enable the Resilient Ring Protocol, use the no disable command.
Defaults Disabled
Command Modes CONFIGURATION (conf-frrp)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series.
7.4.1.0 Introduced.
interface
Configure the primary, secondary, and control-vlan interfaces.
Syntax
interface {primary interface secondary interface control-vlan vlan-id}
To return to the default, use the no interface {primary interface secondary interface
control-vlan vlan-id} command.
Parameters
primary interface Enter the keyword primary to configure the primary interface then one of the
following interfaces and the interface information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the stack/slot/port/subport information.
● For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE
then the stack/slot/port/subport information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
stack/slot/port[/subport] information.
● For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the
stack/slot/port/subport information.
●
For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then
the stack/slot/port information.
Force10 Resilient Ring Protocol (FRRP) 505