Users Guide
● For the Management interface on the stack-unit, enter the keyword
ManagementEthernet then the slot/port information.
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the stack/slot/port/subport information.
● For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE
then the stack/slot/port/subport information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
stack/slot/port[/subport] information.
●
For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the
stack/slot/port/subport information.
● For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then
the stack/slot/port information.
● For a Tunnel interface, enter the keyword tunnel then the tunnel ID. The
range is from 1 to 16383.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
● For a port channel interface, enter the keywords port-channel then a
number.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Added the support for interfaces.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Usage
Information
You cannot delete a physical interface.
By default, physical interfaces are disabled (shutdown) and are not assigned to an IP address or
switchport. To place an interface in Layer 2 mode, ensure that the interface’s configuration does not
contain an IP address and enter the switchport command.
You can create up to 64 tunnel interfaces. The tunnel is added as a logical interface with no default
configuration. To delete a tunnel interface, use the no interface tunnel tunnel-id command.
556 Interfaces