Users Guide

● For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then
the stack/slot/port information.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL Switch.
Usage
Information
The interface group command will create all the non-existent VLANs specified in the range. On
successful command execution, the CLI switches to the interface group context.
The configuration commands inside the group context will be the similar to that of the existing range
command.
Note: For release 9.4(0.0), the group command is supported only for VLANs and physical interfaces.
Example
Related
Commands
● interface range — configure a range of interfaces.
● interface vlan — configures a VLAN.
interface loopback
Configure a Loopback interface.
Syntax
interface loopback number
To remove a loopback interface, use the no interface loopback number command.
Parameters
number Enter a number as the interface number. The range is from 0 to 16383.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
558 Interfaces