Users Guide

Line Description
○ Vlans = number of VLAN tagged packets
○ throttles = packets containing PAUSE frames
○ discarded = number of packets discarded without any processing
○ collisions = number of packet collisions
○ wred=count both packets discarded in the MAC and in the hardware-based
queues
Rate
information...
Estimate of the input and output traffic rate over a designated interval (30 to 299
seconds). Traffic rate is displayed in bits, packets per second, and percent of line
rate.
Time since... Elapsed time since the last interface status change (hh:mm:ss format).
Example
Dell# show interfaces
TenGigabitEthernet 1/1/1/1 is down, line protocol is down
Hardware is DellForce10Eth, address is 00:01:e8:8b:3d:e7
Current address is 00:01:e8:8b:3d:e7
Pluggable media present, Media type is unknown
Wavelength unknown
Interface index is 100992002
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed auto
Flowcontrol rx on tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 3d17h53m
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 3d17h51m
Usage
Information
The Management port is enabled by default (no shutdown). If necessary, use the ip address
command to assign an IP address to the Management port. If two RPMs are installed in your system, use
the show redundancy command to display which RPM is the Primary RPM.
Example
Dell# show interfaces tengigabitethernet 0/0
TenGigabitEthernet 0/0 is down, line protocol is down
Hardware is DellEth, address is 00:01:e8:8a:e9:72
Current address is 00:01:e8:8a:e9:72
Pluggable media present, SFP+ type is 10GBASE-T
Wavelength is 0nm
Interface index is 17105922
Internet address is not set
Mode of IPv4 Address Assignment : NONE
DHCP Client-ID :0001e88ae972
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed auto
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 26w4d22h
Queueing strategy: fifo
580 Interfaces