Users Guide

QSFP28 1/3 Serial ID Extended Fields
QSFP28 1/3 BR max = 0
QSFP28 1/3 BR min = 0
QSFP28 1/3 Vendor SN = APN151700130DP
QSFP28 1/3 Datecode = 150427
QSFP28 1/3 CheckCodeExt = 0x5a
QSFP28 1/3 Extended Transceiver Code = 0x0b
QSFP28 1/3 Diagnostic Information
===================================
QSFP28 1/3 Free Side Properties(far end,near end) = 0
===================================
Related
Commands
● interface — configure a physical interface on the switch.
● show ip interface — display Layer 3 information about the interfaces.
● show interfaces — display information on a specific physical interface or virtual interface.
● show inventory (S-Series and Z-Series) — display the switch type, components (including media), Dell
Networking OS version including hardware identification numbers and configured protocols.
show range
Display all interfaces configured using the interface range command.
Syntax
show range
Command Modes INTERFACE RANGE (config-if-range)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added support for 4093 VLANs on E-Series.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced.
Example
Dell(conf-if-range-te-1/1/2/1,fo-1/1/6)# show range
1/1/2/1 - 0
1/1/6 - 0
Related
Commands
● interface — configure a physical interface on the switch.
● show ip interface — display Layer 3 information about the interfaces.
● show interfaces — display information on a specific physical interface or virtual interface.
596 Interfaces