Users Guide

To return to the default setting, use the no speed command.
Parameters
10 Enter the keyword 10 to set the interface’s speed to 10 Mb/s.
100 Enter the keyword 100 to set the interface’s speed to 100 Mb/s.
1000 Enter the keyword 1000 to set the interface’s speed to 1000 Mb/s.
auto Enter the keyword auto to set the interface to auto-negotiate its speed.
Defaults auto
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the S55, S60, and S4810
8.1.1.0 Introduced on the E-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage
Information
This command is found on the Management interface only.
Related
Commands
● interface ManagementEthernet — configure the Management port on the system (either the Primary
or Standby RPM).
● — configure duplex mode on physical interfaces with the speed set to 10/100.
● management route — configure a static route that points to the Management interface or a
forwarding router.
stack-unit portmode
Convert a single 40G port into 4x10G ports in a 16x40G module and a single 100G port into 2x50G ports, 1x40G port, 4x25G
ports or 4x10G ports in an 8x100G module.
Syntax
stack-unit stack-unit-number module module-number port number portmode
{dual speed 50G | quad speed {25G | 10G} | single speed 40G} [no-confirm]
Parameters
stack-unit Enter the stack member unit identifier of the stack member to reset.
module Enter the keyword module then the module number to specify the optional module
where the port is present.
port Enter the keyword port then the port number to specify the port where fanout
mode is specified.
single Convert a single 100G port into one 40G port.
dual Split a single 100G port into two 50G ports.
Interfaces 599