Users Guide
● ethertype — Use Ethertype field in hash calculation.
● source-dest-mac — Use SMAC and DMAC fields in hash calculation.
tunnel [
ipv4-
over-ipv4
|
ipv4-
over-gre-ipv4
|
mac-in-mac
]}
To use tunnel key fields in hash computation, enter the keyword tunnel then one
of the parameters:
● ipv4-over-ipv4 — Use ipv4-over-ipv4 field in hash calculation.
● ipv4-over-gre-ipv4 — Use ipv4-over-gre-ipv4 field in hash calculation.
● mac-in-mac — Use mac-in-mac field in hash calculation.
Defaults IP selection 5-tuples (source-ip dest-ip vlan protocol L4-source-port L4-dest-port).
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Added support for IPv6.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
management route
Configure a static route that points to the Management interface or a forwarding router.
Syntax
management route {ip-address mask | ipv6-address 1.1.1.1prefix-length}
{forwarding-router-address | managementethernet | fortyGigE | vlan |
tengigabitethernet}
To remove a static route, use the no management route command.
Parameters
ip-address mask
Enter an IP address (dotted decimal format) and mask (/prefix format) of the
destination subnet.
ipv6-address
prefix-length
Enter an IPv6 address (x:x:x:x::x format) and mask (/prefix format) of the
destination subnet. Enter the IPv6 address in the x:x:x:x::x format followed by the
prefix length in the /x format.
The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
forwarding-
router-address
Enter an IP address (dotted decimal format) or an IPv6 address (x:x:x:x::x format)
of a forwarding router.
managementethe
rnet
Enter the keyword managementethernet for the Management interface on the
Primary RPM.
648 IPv4 Routing