Users Guide

To remove this filter, you have two choices:
● Use the no seq sequence-number command syntax if you know the filter’s sequence number
● Use the no permit {ipv6-protocol-number | icmp | ipv6 | tcp | udp} command
Parameters
ip-protocol-
number
Enter an IPv6 protocol number. The range is from 0 to 255.
icmp Enter the keyword icmp to filter internet Control Message Protocol version 6.
ipv6 Enter the keyword ipv6 to filter any internet Protocol version 6.
tcp Enter the keyword tcp to filter the Transmission Control protocol.
udp Enter the keyword udp to filter the User Datagram Protocol.
Defaults Not configured.
Command Modes ACCESS-LIST
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
ipv6 control-plane egress-filter
Enable egress Layer 3 ACL lookup for IPv6 CPU traffic.
Syntax
ipv6 control-plane egress-filter
Defaults Not enabled.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
IPv6 Access Control Lists (IPv6 ACLs) 687