Users Guide

Version Description
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Related
Commands
● show lacp — display the LACP configuration.
debug lacp
Debug LACP (configuration, events, and so on).
Syntax
debug lacp [config | events | pdu [interface-type [in | out]]]
To disable LACP debugging, use the no [config | events | pdu [interface-type [in |
out]]] command.
Parameters
config (OPTIONAL) Enter the keyword config to debug the LACP configuration.
events (OPTIONAL) Enter the keyword events to debug the LACP event information.
pdu (OPTIONAL) Enter the keyword pdu to debug the LACP Protocol Data Unit
information.
interface-type in
| out
(OPTIONAL) Enter the following keywords and the interface information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the stack/slot/port/subport information.
● For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE
then the stack/slot/port/subport information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
stack/slot/port[/subport] information.
● For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the
stack/slot/port/subport information.
● For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then
the stack/slot/port information.
Optionally, enter an in or out parameter:
● Receive enter in
● Transmit enter out
Defaults None
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
760 Link Aggregation Control Protocol (LACP)