Users Guide

Related
Commands
● fefd — enable far-end failure detection.
● fefd-global interval — configure an interval between FEFD control packets.
● show fefd — display the FEFD command output.
show fefd
View FEFD status globally or on a specific interface.
Syntax
show fefd [interface]
Parameters
interface (OPTIONAL) Enter the following keywords and the interface information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the stack/slot/port/subport information.
● For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE
then the stack/slot/port/subport information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
stack/slot/port[/subport] information.
● For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the
stack/slot/port/subport information.
● For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then
the stack/slot/port information.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.12.0 Introduced on the S4810.
Legacy E-Series
command.
Usage
Information
The following describes the show fefd command shown in the following example.
Field Description
Interface Displays the interfaces type and number.
Mode Displays the mode (aggressive or normal) or NA if the interface contains fefd
reset in its configuration.
Interval Displays the interval between FEFD packets.
State Displays the state of the interface and can be one of the following:
Layer 2 795