Users Guide

Enter the CAM profile name then the amount of CAM space to be allotted. The
total space allocated must equal to 9. The ipv6acl range must be a factor of 3.
Enter 4 or 8 for the number of OpenFlow FP blocks.
● 4: Creates 242 entries for use by the OpenFlow controller (256 total entries
minus the 14 entries reserved for internal functionality)
● 8: Creates 498 entries for use by the OpenFlow controller (512 total entries
minus the 14 entries reserved for internal functionality)
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.2(0.2) Added support for the fcoe parameter on the S4810 and S4820T.
9.1.(0.0) Added support for OpenFlow on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Added the keywords fcoeacl and iscsioptacl on the S4810.
8.3.11.1 Introduced on the Z9000.
8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-dual-qos.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage
Information
For the new settings to take effect, save the new CAM settings to the startup-config (write-mem or
copy run start) then reload the system.
The total amount of space allowed is 16 FP Blocks. System flow requires three blocks and these blocks
cannot be reallocated. The ipv4acl profile range is from 0 to 8.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 9.
The ipv6acl allocation must be a factor of 3 (0,3,6,9).
If you enabled BMP, to perform a reload on the chassis to upgrade any configuration changes that have
changed the NVRAM content, use the reload conditional nvram-cfg-change command.
clear line
Reset a terminal line.
Syntax
clear line {line-number | console 0 | vty number}
Parameters
line-number Enter a number for one of the 12 terminal lines on the system. The range is from 0
to 11.
console 0 Enter the keywords console 0 to reset the console port.
Control and Monitoring 81