Administrator Guide

• enable — Takes the source port into consideration when doing hash computations.
This option is disabled by default.
Defaults IP 4-tuple (IP SA, IP DA, Source Port, Destination Port)
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Added the ingress-port parameter for the S4810.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage Information By default, Dell Networking OS distributes incoming trac based on a hash algorithm using the following criteria:
• IP source address
• IP destination address
• TCP/UDP source port
• TCP/UDP destination port
load-balance hg
Choose the trac ow parameters the hash calculation uses while distributing the trac across internal higig links.
Syntax
[no] load-balance hg {ip-selection | ipv6-selection [source-ip | source-ipv6 |
source-port-id | source-module-id | dest-ip | dest-ipv6 | dest-port-id | dest-
module-id | protocol | vlan | L4-source-port | L4-dest-port ] | mac [source-mac
| source-port-id | source-module-id | dest-mac | dest-port-id | dest-module-id
| vlan | ethertype | source-dest-mac ] | tunnel [ipv4-over-ipv4 | ipv4-over-
gre-ipv4 | mac-in-mac]}
Parameters
{{ip-selection| ipv6-
selection [source-ip
| source-ipv6 |
To use IPv4 key elds in hash computation, enter the keyword ip-selection then one
of the parameters. To use IPv6 key elds in hash computation, enter the keyword ipv6-
selection
then one of the parameters.
IPv4 Routing 791