Administrator Guide

port-set pipe-
number
Enter the keyword port-set then the number of the stack unit’s port-pipe.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to display CAM entries
corresponding to that VRF.
network mask
[longer-prexes
[ecmp-group
detail]]
(OPTIONAL) Enter the IP address and mask of a route to CAM entries for that route only.
You can enter one of the following keywords to lter results.
• Enter the keyword longer-prefixes to view routes with a common prex.
• Enter the keyword ecmp-group detail to view the ECMP group index.
ecmp-group {detail
| member-info
[detail [group-index
index-number]]}
(OPTIONAL) Enter the keyword ecmp-group then one of the following keywords to
lter results.
• Enter the keyword detail to view the ECMP group index.
• Enter the keyword member-info to view the member information for the ECMP
group.
•
Enter the keyword member-info detail to view detailed ECMP membership and
n-hop information.
• Enter the keyword group-index then the index number to show ECMP
membership per group. The range is from 0 to 1022.
summary (OPTIONAL) Enter the keyword summary to view a table listing route prexes and the
total number routes which can be entered in to CAM.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Added support for VRF.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Added support for up to seven stack members.
7.6.1.0 Introduced on the S-Series.
Usage Information The following describes the show ip cam command shown in the following example.
800 IPv4 Routing