Administrator Guide

ipv6 unicast (OPTIONAL) Enter the keyword ipv6 followed by the keyword unicast to reset ipv6
unicast routes.
soft (OPTIONAL) Enter the keyword soft to reset soft configuration.
in Enter the keyword in to re-configure soft inbound updates.
out Enter the keyword out to re-configure soft outbound updates.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added the ipv4 multicast and ipv6 unicast parameters.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
debug ip bgp
Display all information on BGP, including BGP events, keepalives, notifications, and updates.
Syntax
debug ip bgp [ vrf vrf-name | A.B.C.D | X:X:X:X::X | peer-group peer-group-
name] [in | out]
To disable all BGP debugging, use the no debug ip bgp command.
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to debug BGP information
corresponding to that VRF.
NOTE: Use this attribute to debug BGP protocol operations corresponding
to either a default or non-default VRF.
A.B.C.D Enter the IPv4 address of the neighbor in dotted decimal format.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
peer-group peer-
group-name
Enter the keywords peer-group then the name of the peer group to debug.
in (OPTIONAL) Enter the keyword in to view only information on inbound BGP routes.
out (OPTIONAL) Enter the keyword out to view only information on outbound BGP routes.
Border Gateway Protocol 357