Administrator Guide

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0. Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage Information When you enable this command, if a Policy Map containing classification rules (ACL and/or dscp/ ip-precedence
rules) is applied to more than one physical interface on the same port pipe, only a single copy of the policy is
written (only one FP entry is used).
NOTE: An ACL itself may still require more that a single FP entry, regardless of the number of
interfaces. For more information, refer to the “IP Access Control Lists”, “Prefix Lists”, and
“Route-map” sections in the Dell EMC Networking OS Configuration Guide .
cam-sharing
Enable IPV4 QOS CAM sharing with the IPV6 ACL CAM region.
Syntax
cam-sharing ipv4qos value ipv6acl value
Parameters
ipv4qos value Enter the ipv4qos keyword and a value in percentage.
ipv6acl value Enter the ipv6acl keyword and a value in percentage.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Introduced on the S6100–ON and Z9100–ON.
Usage Information
Use the cam-sharing command to share the IPV6 ACL CAM region with the IPv4 QOS CAM region. You can
partition the CAM as per the sharing requirements and both IPV6 ACLs and IPV4 QOS ACLs are installed on the
same CAM region.
You can enable this command only after using the feature ipv6acloptimized command on the system.
When you use this feature, set either the IPv4 QoS or the IPv6 ACL CAM region to zero using the cam-acl
command
Save the configuration and reload the system for the change to take effect.
The IPv4 QoS region reserves 32 ACLs. Sharing is calculated on the remaining ACLs. For example, if you configure
the IPv6 ACL value as 2, the system reserves 32 entries for IPv4 QoS and the remaining 224 entries (256-32) are
shared between IPv4 QoS and IPv6 ACL entries according to the configured CAM sharing percentages.
The sum of the percentage values between the two regions must be 100.
Example
The following example shows that IPv4 QoS is disabled and IPv6 ACL is set to 4. With this configuration, you can
share a total of 480 entries between the IPv4 QoS and IPv6 ACL regions after allocating 32 entries for IPv4 QoS.
DellEMC(conf)# cam-sharing ipv4qos 50 ipv6acl 50
DellEMC(conf)#cam-acl l2acl 0 ipv4acl 0 ipv6acl 4 ipv4qos 0 l2qos 0 l2pt 0
ipmacacl 1 vman-qos 0
Content Addressable Memory (CAM) 441