Administrator Guide

cam-threshold
Configure CAM threshold value for sending the syslog message on CAM usage. Configure silence period for stop receiving syslog message
on CAM usage.
Syntax
cam-threshold threshold {default | threshold-percent} silence-period {default |
silence-period-value}
Defaults
Enabled
Parameters
threshold default
Enter the keyword default for CAM usage threshold for notification of the CAM usage
through syslog message. The default threshold value is 90 percent.
threshold
threshold-percent
Enter the threshold percent for notification of the CAM usage through syslog message.
The range is from 1 to 100 percent.
silence-period
default
Enter the keyword default to set the silence period for receiving syslog message
regarding CAM usage for CAM region, slot/portpipe. The default silence period is 0
seconds.
silence-period
silence-period-
value
Enter the silence period for stop receiving syslog message for the respective CAM region,
slot/portpipe. The range is from 0 to 65535 seconds.
Command Modes CONFIGURATION
Supported Modes
Command History
Version Description
9.14.1.0 Introduced on the S4810 and S4820T.
9.13.0.0 Introduced on the MXL, FN IOM, S5000, S4048-ON, S6000, S6000-ON, S3048-ON,
S3100 Series, C9010, S4048T-ON, Z9500, Z9100-ON, S6100-ON, S6010-ON.
Usage Information
The no cam-threshold command will set the CAM threshold to 90 percent and silence period to 0.
The CAM threshold and silence period configuration is applicable only for Ingress L2, IPv4, IPv6 and Egress L2,
IPv4, and IPv6 ACL CAM groups. For other ACL CAM regions, the CAM threshold and silence period is not
configurable and the values are fixed to 90 percent and 0 respectively.
Example
DellEMC(conf)#cam-threshold threshold 2 silence-period 2
DellEMC(conf)#do show running-config | g cam-threshold
cam-threshold threshold 2 silence-period 2
feature ipv6acloptimized
Convert the IPv6 ACL CAM to double-wide.
Syntax
feature ipv6acloptimized
To disable this feature, use the no feature ipv6acloptimized command.
Command Modes CONFIGURATION
Defaults Not configured
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Introduced on the S5048F–ON, S6100–ON, and Z9100–ON..
442 Content Addressable Memory (CAM)