Administrator Guide

Parameters
bmp-reload Reloads using the bare metal provisioning mode
fastboot Reloads using the fastboot mode
normal-reload Reloads using the standard, manual interactive mode
warmboot Reloads using the warmboot mode
Defaults normal-reload
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.12(0.0) Introduced on the S6000, S6100–ON and Z9100–ON
Usage Information Once you enter reload-type, you need to enter the boot-type required on the next reboot. After
configuring boot-type you need to save the configuration with the write cli to make it active.
Example
DellEMC(conf-reload-type)#boot-type warmboot
DellEMC(conf-reload-type)#end
Dell#
cam-acl
Allocate content addressable memory (CAM) for IPv4 and IPv6 ACLs.
Syntax
cam-acl {default | l2acl number ipv4acl number ipv6acl number ipv4qos number
l2qos number l2pt number ipmacacl number [vman-qos | vman-dual-qos] number
{fcoeacl number} {openflow {4|8}}
Parameters
default Use the default CAM profile settings and set the CAM as follows:
• L2Acl : 2
• Ipv4Acl : 2
• Ipv6Acl : 0
• Ipv4Qos : 2
• L2Qos : 2
• L2PT : 0
• IpMacAcl : 1
• VmanQos : 0
• EtsAcl : 0
• FcoeAcl : 0
• ipv4pbr : 0
• vrfv4Acl : 0
• Openflow : 0
• fedgovacl : 0
• nlbclusteracl: 0
• ipv4udfmirracl: 0
• ipv4mirracl: 0
cam-acl {default |
l2acl number
ipv4acl number
ipv6acl number ,
ipv4qos number
l2qos
number l2pt numbe
r ipmacacl number
Allocate space to each CAM region.
Enter the CAM profile name then the amount of CAM space to be allotted. The total
space allocated must equal to 9. The ipv6acl range must be a factor of 3.
Enter 4 or 8 for the number of OpenFlow FP blocks.
•
4: Creates 242 entries for use by the OpenFlow controller (256 total entries minus the
14 entries reserved for internal functionality)
86 Control and Monitoring