Users Guide

Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
Usage Information
Neighbor Discovery Protocol for IPv6 is dened in RFC 2461 as part of the Stateless Address Autoconguration
protocol. It replaces the Address Resolution Protocol used with IPv4. It denes mechanisms for solving problems,
such as:
• Router discovery: Hosts can locate routers residing on a link.
• Prex discovery: Hosts can discover address prexes for the link.
• Parameter discovery .
• Address autoconguration — conguration of addresses for an interface .
• Address resolution — mapping from IP address to link-layer address.
• Next-hop determination.
• Neighbor Unreachability Detection (NUD): Determine that a neighbor is no longer reachable on the link.
• Duplicate Address Detection (DAD): Allow a node to check whether a proposed address is already in use.
• Redirect: The router can inform a node about a better rst-hop.
Use the ipv6 neighbor command to manually congure the IPv6 address of a neighbor to be discovered by the
switch.
managed-cong-ag
Set the managed address conguration ag.
Syntax
managed-config-flag {on | off}
To clear the ag, use the no managed-config-flag {on | off} command.
Parameters
on Enter the keyword on to set the managed-cong-ag value as ON.
o Enter the keyword off to set the managed-cong ag value as OFF.
Defaults None
Command Modes POLICY LIST CONFIGURATION
1034 Neighbor Discovery Protocol (NDP)