Users Guide

Default is No.
validate-reply (IPv4 only) Enter Y or N for reply validation.
• N: Do not validate reply data.
• Y: Do validate reply data.
Default is No.
outgoing-interface (IPv6 link-local address) Enter the outgoing interface for ping packets to a destination
link-local address.
pattern pattern (IPv4 only) Enter the IPv4 data pattern. Range: 0-FFFF. Default: 0xABCD.
sweep-min-size Enter the minimum size of datagram in sweep range. The range is from 52 to 15359 bytes.
sweep-max-size Enter the maximum size of datagram in sweep range. The range is from 53 to 15359
bytes.
sweep-interval Enter the incremental value for sweep size. The range is from 1 to 15308 seconds.
interface (IPv4 only) Enter the outgoing interface for multicast packets. Enter the IP address in
A.B.C.D format.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
• For a port channel interface, enter the keywords port-channel then a number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
ethernet Enter the keyword ethernet to test layer2 connectivity.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to test connectivity to the VRF.
Defaults None.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0)P5 Introduced on the S4048–ON.
9.8(0.0)P2 Introduced on the S3048–ON.
9.2(1.0) Introduced on the Z9500.
Control and Monitoring 117