Users Guide

Usage Information
You can attach an interface to either a nondefault VRF or a management VRF.
To assign a port-back to a default VRF, remove the VRF association from the interface. You can use this only if
there is no IP address congured on the interface.
There must be no prior Layer 3 conguration on the interface when conguring VRF.
You must enable VRF before using this command.
You can congure an IP subnet or address on a physical or VLAN interface that overlaps the same IP subnet or
address congured on another interface only if the interfaces are assigned to dierent VRFs. If you assign two
interfaces to the same VRF, you cannot congure overlapping IP subnets or the same IP address to them.
Example
Dell# configure terminal
Dell(conf)# ip vrf red
Dell(conf-vrf)# description "Red Network"
Dell(conf-vrf)# show config
!
ip vrf red 4
description "Red Network"
Dell(conf-vrf)#
Dell(conf-if-te-1/1/4/1)# int tengigabitethernet 1/1/4/2
Dell(conf-if-te-1/1/4/2)# no shut
Dell(conf-if-te-1/1/4/2)# ip vrf forwarding red
Dell(conf-if-te-1/1/4/2)# ip add 100.1.1.1/24
Dell(conf-if-te-1/1/4/2)#
Dell(conf-if-te-1/1/4/2)#
Dell(conf-if-te-1/1/4/2)#
Dell(conf-if-te-1/1/4/2)# show config
!
interface TenGigabitEthernet 1/1/4/2
ip vrf forwarding red
ip address 100.1.1.1/24
no shutdown
Dell(conf-if-te-1/1/4/2)#
ip http vrf
Congure an HTTP client with a VRF used to connect to the HTTP server.
Syntax
ip http vrf {management | vrf-name}
To undo the HTTP client conguration, use the ip http vrf command.
Parameters
management Enter the keyword management for conguring the management VRF that uses an
HTTP client.
vrf-name Enter a VRF name that the HTTP client uses. If you do not specify a VRF name, the
HTTP client uses the default VRF.
Defaults Disabled
Command Modes CONFIGURATION
1652 Virtual Routing and Forwarding (VRF)