Users Guide

set extcommunity bandwidth
Enables you to set extended community bandwidth.
Syntax
set extcommunity bandwidth
To disable extended community bandwidth, enter the no set extcommunity bandwidth command.
Parameters
bandwidth Enter the keyword bandwidth to enable extended community bandwidth. The range is
from 0 to 102400.
Defaults N/A
Command Modes ROUTER MAP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S-Series.
Usage Information
A new policy command is introduced in order to attach the Link Bandwidth extended community only to the
prexes that are received from a neighbor that satisfy the desired conditions. This command is relevant for both
inbound as well as outbound policy handling (for received prexes). Also, there is no change to the set of
supported conditions or lters.
During conguration, the bandwidth is specied in Mbps, not in bytes/second. While creating the actual LB
extended community, the system will attach the AS number and encode the bandwidth in oating point format.
show capture bgp-pdu neighbor
Display BGP packet capture information for an IPv4 address on the system.
Syntax
show capture bgp-pdu neighbor ipv4-address
Parameters
ipv4-address Enter the IPv4 address (in dotted decimal format) of the BGP address to display packet
information for that address.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Border Gateway Protocol 413