Users Guide

Parameters
ipv4 multicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword multicast to view
information related only to ipv4 multicast routes.
ipv4 unicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword unicast to view
information related only to ipv4 unicast routes.
ipv6 unicast (OPTIONAL) Enter the keyword ipv6 followed by the keyword unicast to view
information related only to ipv6 unicast routes.
peer-group-name (OPTIONAL) Enter the name of a peer group to view information about that peer group
only.
detail (OPTIONAL) Enter the keyword detail to view detailed status information of the peers
in that peer group.
summary (OPTIONAL) Enter the keyword summary to view status information of the peers in that
peer group. The output is the same as that found in the show ip bgp summary
command.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Added the add-path option to the S4810. Output on the S4810 shows the ADDPATH
parameters.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
The following describes the show ip bgp peer-group command shown in the following example.
Line beginning
with:
Description
Peer-group Displays the peer group’s name.
Administratively
shut
Displays the peer group’s status if the peer group is not enabled. If you enable the peer
group, this line is not displayed.
BGP version Displays the BGP version supported.
440 Border Gateway Protocol