Users Guide

Version Description
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
Usage Information You must save the new ECMP settings to the startup-cong (write-mem) then reload the system for the new
settings to take eect.
ip ecmp weighted
Enables weighted ECMP calculations.
Syntax
ip ecmp weighted
To disable weighted ECMP calculations, enter the no ip ecmp weighted command.
Defaults N/A
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S-Series.
Usage Information
Enabling this CLI would inform the FIB to re-program the destination prex paths with weights in the HW/CAM on
the y.
If disabled, the CLI would inform the FIB to re-program the destination prex paths with no weights or regular
ECMP.
Example
Dell(conf)# ip ecmp ?
weighted Enables Weighted ECMP
Dell(conf)# ip ecmp weighted
Dell(conf)#do show running-config | grep ecmp
ip ecmp weighted
Dell(conf)#
Dell(conf)# no ip ecmp ?
weighted Disables Weighted ECMP
Dell(conf)# no ip ecmp weighted
Dell(conf)# do show running-config | grep ecmp
Equal Cost Multi-Path (ECMP) 587