Users Guide

rate-interval (Conguration Mode)
Congure the trac sampling interval for all physical and logical port-channel interfaces globally. The support to congure rate-interval
globally enables you to modify the default interval rate for all physical and logical interfaces at one time.
Syntax
rate-interval seconds
Use the no rate-interval command to remove the sampling interval conguration.
Parameters
seconds Enter the number of seconds for which to collect trac data. The range is from 5 to 299
seconds.
NOTE: Because polling occurs every 15 seconds, the number of seconds
designated here round to the multiple of 15 seconds lower than the entered
value. For example, if 44 seconds is designated, it rounds to 30; 45 to 59
seconds rounds to 45. If you congure this value to be less than 5, then the
entire buer is cleared; the show int stats command shows the rate
information to be 0 as the polling interval is less than 5.
Defaults 299 seconds
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.11.0.0 Introduced on all Dell Networking OS platforms.
Usage Information
The output of the show interfaces command displays the congured rate interval, along with the collected
trac data.
When rate-interval is not congured in the global conguration mode or interface mode, the default value of 299
seconds is applied.
When rate-interval is congured only in the global conguration mode and not in the interface mode, the global
rate-interval value is applied at the interface level also.
When rate-interval is congured at the interface level and not in the global conguration mode, the interface level
rate-interval value is applied for an interface.
When rate interval is congured in both global conguration mode as well as interface mode, then the rate-interval
value congured at interface level is applied as it takes precedence over the global value.
show cong
Display the interface conguration.
Syntax
show config
Command Modes INTERFACE
Interfaces 697