Users Guide

Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version 6.2.1.0 Introduced on the E-Series.
Example
Dell(conf-if-hu-1/4)# show config
!
interface HundredGigE 1/4
no ip address
mtu 9416
switchport
no shutdown
Dell(conf-if-hu-1/4)#
show cong (for speed)
Syntax
show config
Command Modes INTERFACE MODE
Command History
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.3(0.1) Introduced on the S6000.
Usage Information
In order for the speed information corresponding to an interface to appear in the show command output, you must
rst congure the speed of that interface using the speed command.
Example
698 Interfaces