Users Guide

Usage Information
For the new settings to take eect, save the new CAM settings to the startup-cong (write-mem or copy run
start), then reload the system.
The total amount of space allowed is 4 FP Blocks.
Example
Dell# configure
Dell(conf)# cam-acl-egress ?
default Reset Egress CAM ACL entries to default setting
l2acl Set L2-ACL entries
Dell(conf)# cam-acl-egress l2acl ?
<1-4> Number of FP blocks for l2acl
Dell(conf)# cam-acl-egress l2acl 1 ?
ipv4acl Set IPV4-ACL entries
Dell(conf)# cam-acl-egress l2acl 1 ipv4acl 1 ?
ipv6acl Set IPV6-ACL entries
Dell(conf)# cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl ?
<0-4> Number of FP blocks for IPV6 (multiples of 2)
Dell(conf)# cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl 2
Dell(conf)#
cam-acl
Allocate space for IPv6 ACLs.
Syntax
cam-acl {default | l2acl 1-10 ipv4acl 1-10 ipv6acl 0-10 ipv4qos 1-10 l2qos
1-10}
Parameters
default Use the default CAM prole settings, and set the CAM as follows:
• L3 ACL (ipv4acl): 2
• L2 ACL(l2acl): 2
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 2
• L2 QoS (l2qos): 2
l2acl 1-10 ipv4acl
1-10 ipv6acl 0-10
ipv4qos 1-10 l2qos
1-10
Allocate space to support IPv6 ACLs. Enter all of the proles and a range. Enter the CAM
prole name then the amount to be allotted. The total space allocated must equal 9. The
ipv6acl range must be a factor of 3 (0,3,6,9).
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
832 IPv6 Access Control Lists (IPv6 ACLs)