Users Guide

prex-list-name Enter the name of a congured IP prex list. Routes meeting the criteria of the IP Prex
list are leaked.
Defaults level1-into-level2 (Level 1 to Level 2 leaking is enabled.)
level2–into-level1 (Level 2 to Level 1) leaking is disabled.
Command Modes
• ROUTER ISIS (for IPv4)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
7.5.1.0 Added IPv6 ISIS support.
6.3.1.0 Version 6.3.1.0 Introduced
Usage Information
You cannot disable leaking from Level 1 to Level 2. Also, you cannot enable leaking from Level 2 to Level 1. However,
you can regulate the rate ow from one level to another using an IP Prex list. If you do not congure the IP Prex
list, all Level 1 routes are leaked.
You can nd more information in IETF RFC 2966, Domain-wide Prex Distribution with Two-Level IS-IS.
area-password
Congure a hash message authentication code (HMAC) password for an area.
Syntax
area-password [hmac-md5 | encryption-type] password
To delete a password, use the no area-password command.
Parameters
hmac-md5 (OPTIONAL) Enter the keywords hmac-md5 to encrypt the password.
encryption-type (OPTIONAL) Enter 7 to encrypt the password using DES.
Intermediate System to Intermediate System (IS-IS) 837