Users Guide
Related Commands
• lsp-refresh-interval — set the link-state packet (LSP) refresh interval.
maximum-paths
Allows you to congure the maximum number of equal cost paths allowed in a routing table.
NOTE: Enables you to congure a single system wide value that is common for both IPv4 and IPv6 addresses.
Syntax
maximum-paths number
To return to the default values, use the no maximum-paths command.
Parameters
number Enter a number as the maximum number of parallel paths an IP routing installs in a routing
table. The range is from 1 to 64. The default is 4.
Defaults 4
Command Modes
• ROUTER ISIS (for IPv4)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
7.8.1.0 Added support for multi-topology ISIS.
6.3.1.0 Introduced.
metric-style
To generate and accept old-style, new-style, or both styles of type, length, and values (TLV), congure a router.
Syntax
metric-style {narrow [transition] | transition | wide [transition]} [level-1 |
level-2]
878 Intermediate System to Intermediate System (IS-IS)