Administrator Guide

Example of the test cam-usage Command
DellEMC#test cam-usage service-policy input test-cam-usage stack-unit 1 po 0
Stack-Unit| Portpipe|CAM Partition|Available CAM|Estimated CAM per Port|Status
------------------------------------------------------------------------------------
2 | 0 |IPv4Flow |192 |3 |Allowed (64)
DellEMC#
View CAM-ACL Settings
The show cam-acl command shows the cam-acl setting that will be loaded after the next reload.
Example of Viewing CAM-ACL Settings
DellEMC#show cam-acl
-- Chassis Cam ACL --
Current Settings(in block sizes) Next Boot(in block sizes)
1 block = 256 entries
L2Acl : 2 2
Ipv4Acl : 2 2
Ipv6Acl : 0 3
Ipv4Qos : 2 2
L2Qos : 2 0
L2PT : 0 0
IpMacAcl : 1 0
VmanQos : 0 0
EtsAcl : 0 0
FcoeAcl : 0 0
ipv4pbr : 0 0
vrfv4Acl : 0 0
Openflow : 0 0
fedgovacl : 0 0
nlbclusteracl: 0 0
-- stack-unit 1 --
Current Settings(in block sizes) Next Boot(in block sizes)
1 block = 256 entries
L2Acl : 2 2
Ipv4Acl : 2 2
Ipv6Acl : 0 3
Ipv4Qos : 2 2
L2Qos : 2 0
L2PT : 0 0
IpMacAcl : 1 0
VmanQos : 0 0
EtsAcl : 0 0
FcoeAcl : 0 0
ipv4pbr : 0 0
vrfv4Acl : 0 0
Openflow : 0 0
fedgovacl : 0 0
nlbclusteracl: 0 0
DellEMC#
NOTE:
If you change the cam-acl setting from CONFIGURATION mode, the output of this command does not reflect any
changes until you save the running-configuration and reload the chassis.
Example of Viewing CAM-ACL Settings
DellEMC#show cam-acl
-- Chassis Cam ACL --
Current Settings(in block sizes)
1 block = 256 entries
L2Acl : 2
Ipv4Acl : 2
Ipv6Acl : 0
Content Addressable Memory (CAM)
229