Administrator Guide

no ip address
shutdown
!
interface hundredGigE 1/1/3
no ip address
shutdown
!
interface hundredGigE 1/1/4
no ip address
shutdown
Resetting an Interface to its Factory Default State
You can reset the configurations applied on an interface to its factory default state. To reset the configuration, perform the following
steps:
1. View the configurations applied on an interface.
INTERFACE mode
show config
DellEMC(conf-if-te-1/1/5/1)#show config
!
interface TenGigabitEthernet 1/1/5/1
no ip address
portmode hybrid
switchport
rate-interval 8
mac learning-limit 10 no-station-move
no shutdown
2. Reset an interface to its factory default state.
CONFIGURATION mode
default interface interface-type]
DellEMC(conf)#default interface tengigabitethernet 1/1/5/1
3. Verify the configuration.
INTERFACE mode
show config
DellEMC(conf-if-te-1/1/5/1)#show config
!
interface TenGigabitEthernet 1/1/5/1
no ip address
shutdown
All the applied configurations are removed and the interface is set to the factory default state.
Enabling a Physical Interface
After determining the type of physical interfaces available, to enable and configure the interfaces, enter INTERFACE mode by using the
interface interface command.
1. Enter the keyword interface then the type of interface and slot/port[/subport] information.
CONFIGURATION mode
interface interface
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the stack/slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the stack/slot/port information.
2. Enable the interface.
360
Interfaces