Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S6100-ON
261262263264265266267268269270
Congure Enhanced Transmission Selection
ETS provides a way to optimize bandwidth allocation to outbound 802.1p classes of converged Ethernet trac.
Dierent trac types have dierent service needs. Using ETS, you can create groups within an 802.1p priority class to congure dierent
treatment for trac with dierent bandwidth, latency, and best-eort needs.
For example, storage trac is sensitive to frame loss; interprocess communication (IPC) trac is latency-sensitive. ETS allows dierent
trac types to coexist without interruption in the same converged link by:
• Allocating a guaranteed share of bandwidth to each priority group.
• Allowing each group to exceed its minimum guaranteed bandwidth if another group is not fully using its allotted bandwidth.
Creating an ETS Priority Group
An ETS priority group species the range of 802.1p priority trac to which a QoS output policy with ETS settings is applied on an egress
interface. Before conguring ETS, use the cam-acl l2acl 2 ipv4acl 0 ipv6acl 0 ipv4qos 2 l2qos 0 l2pt 0
ipmacacl 0 vman-qos 0 fcoeacl 2 etsacl 1 iscsi 2 command to allocate the appropriate CAM region for ETS.
1 Congure a DCB Map.
CONFIGURATION mode
dcb-map dcb-map-name
The dcb-map-name variable can have a maximum of 32 characters.
2 Create an ETS priority group.
CONFIGURATION mode
priority-group group-num {bandwidth bandwidth | strict-priority} pfc off
The range for priority group is from 0 to 7.
Set the bandwidth in percentage. The percentage range is from 1 to 100% in units of 1%.
Committed and peak bandwidth is in megabits per second. The range is from 0 to 40000.
Committed and peak burst size is in kilobytes. Default is 50. The range is from 0 to 10000.
3 Congure the 802.1p priorities for the trac on which you want to apply an ETS output policy.
PRIORITY-GROUP mode
priority-list value
The range is from 0 to 7.
The default is none.
Separate priority values with a comma. Specify a priority range with a dash. For example, priority-list 3,5-7.
4 Exit priority-group conguration mode.
PRIORITY-GROUP mode
exit
5 Repeat Steps 1 to 4 to congure all remaining dot1p priorities in an ETS priority group.
6 Specify the dot1p priority-to-priority group mapping for each priority.
priority-pgid dot1p0_group_num dot1p1_group_num ...dot1p7_group_num
Data Center Bridging (DCB)
263